Problem Solving 3 min read

Why Is My Travertine Still Cloudy After Cleaning or Sealing?

Cloudy travertine is almost never dirt. It is mineral buildup, etching, or an old sealer, and each one needs a different fix. Here is how to tell which you have.

Dull, dirty travertine pool deck before cleaning

If travertine still looks cloudy after you clean it, the haze is usually not dirt. It is one of three things: minerals bonded to the surface, etching from an acidic cleaner, or an old sealer that has worn and turned hazy. Cleaning harder does not fix any of them, and sealing over it locks the haze in.

Dull, dirty travertine pool deck pavers before cleaning in Las Vegas

How to tell what the haze is

What you see or feelMost likelyWhat fixes it
White, rough, or crusty. Worst near waterHard water mineralsDeposit removal, then refinishing
Smooth but dull. Looks fine wet, dull again when dryEtching or wear in the finishHoning and polishing
Milky, patchy, sticky, or peelingOld or over-applied sealerRemoving the sealer, then resealing
Dark dots and gray grout linesSoil packed in the holesExtraction cleaning and filling

Most floors and pool decks have more than one of these at once. That is why we look at the stone before quoting.

Why it happens so often in Las Vegas

  • Hard water. Sprinklers, pool splash, and mop water leave minerals behind every time they dry.
  • Acidic cleaners. Travertine is a calcium stone. Vinegar, bathroom descalers, and many tile cleaners dull it on contact.
  • Sun. Outdoor sealers break down fast in full sun and turn cloudy before they wear off.

Filling the holes is not sealing

Fill and sealer do two different jobs. Fill closes the holes so they stop collecting dirt. Sealer slows what soaks into the stone around them. A sealer cannot replace missing fill, and new fill does not seal the floor.

Travertine floor tile with open holes and pits, photo sent in by a customer Travertine pool deck after cleaning, repair, and sealing

What not to do

  1. Do not seal over the haze. It will still be there, under a new layer.
  2. Do not reach for acid. It removes the minerals and etches the stone in the same pass.
  3. Do not keep adding coats to even out a patchy sealer. It gets patchier.

How we fix it

We test a small area first so you see the result. Then we clean with hot water extraction, take off the deposits or the old sealer, hone the finish back, fill open holes, and seal with a product suited to where the stone is. If the surface only needs a deep clean and a fresh sealer, that is our travertine cleaning and sealing service. If it is etched, worn, or pitted, it needs travertine restoration. Around a pool, see pool deck restoration.

Frequently asked questions

Will a stronger cleaner remove the cloudiness?

Usually not. If the finish is etched or the sealer has failed, there is nothing left to clean off. A stronger cleaner often makes it worse.

My travertine looks great wet and dull when it dries. Why?

Water fills the tiny scratches and etching for a moment. That tells you the finish is worn, and honing will bring it back.

Is the white line at my pool the same problem?

That is calcium scale on the tile. It is a separate job: pool tile cleaning.

Not sure which haze you have? Send us a photo for a free estimate.

Tags:

travertine cleaningcloudy travertinetravertine hazetravertine sealerLas Vegas